Re: RE: won't boot
Jason Mangiafico <[email protected]> Tue, 4 May 2004 18:07:37 -0400
| Newsgroups | gmane.comp.hardware.openbrick.general |
|---|---|
| Message-ID | <1ejhbzrttqa5f5s.040520041807@oemcomputer> |
Thanks, that was the problem. I booted into DOS, installed, now it's running Redhat. Next question: First step into getting the hard drive can spin down, is it possible to disable file buffers, and just write the data to disk immediately? ==== "Marc Wetzel" <[email protected]> Wrote: > >Perform the following steps on the system you used to install DOS: > >Install Harddrive as C: >Boot to Dos >type "fdisk /mbr" to install a new masterboot record > >That should fix your linux masterboot record. > >Greetings >/Marc >> >> -----Original Message----- >> From: [email protected] >> [mailto:[email protected]] On Behalf Of Jason Mangiafico >> Sent: Sunday, May 02, 2004 4:46 AM >> To: [email protected] >> Subject: [Openbrick] won't boot >> >> >> What is... >> >> Kernel Panic: kernel compiled for pentium+, requires TSC >> >> >> I ordered my openbrick without an OS or hard drive. I had my >> own 20gb hard drive, removed the partitions, reformatted to >> fat32, put on a clean install of DOS. Yet, it looks like >> it's trying to boot to Linux??? What????