Re: Is Storever still alive?

"Bao C. Ha" <[email protected]> Wed, 24 Sep 2003 12:30:13 -0400
Newsgroups gmane.comp.hardware.openbrick.general
Message-ID <20030924163013.GA11808@minhnam>
On Wed, Sep 24, 2003 at 12:46:50PM +0100, Iain Mac Donald wrote:

Hi Iain,

The minimum debian that can boot is about 125M. Then you can build on
top of it.  If you use a disk, it does not matter. It is difficult to
find a disc smaller than 40G now-a-day.  Using CF, you will have to
be carefull about the number of write cycles. They are not as robust!
Using DOM is another solution, but I don't know if anybody has tried
it.

Thanks.
Bao

> On Wed, 2003-09-24 at 10:47, jean marc bouyer wrote:
> 
> > 
> > I've heard that the debian base is around 300MB
> > 
> 
> Thanks for the reply Jean Marc. My fault for not being precise enough.
> Is that an X11 or console mode only install? I am trying to
> price/configure a project using the Brick where I will need X11 plus
> Java VM. I need to use a disc but the smaller and cheaper the better.
> 
> 
> Regards,
> 
> Iain.
> 
> 
> _______________________________________________
> Openbrick mailing list
> [email protected]
> http://www.openbrick.org/mailman/listinfo/openbrick

-- 
Best Regards.
Bao C. Ha
Hacom OpenBrick Distributor USA http://www.hacom.net
voice: (714) 530-8817 fax: (714) 530-8818
8D66 6672 7A9B 6879 85CD 42E0 9F6C 7908 ED95 6B38