Re: use VGA@60Hz

Christopher Ruehl <[email protected]> Mon, 1 Dec 2003 08:48:39 +0100

Newsgroups	gmane.comp.hardware.openbrick.general
Message-ID	<[email protected]>

On Sun, Nov 30, 2003 at 04:00:55PM +0100, Christopher Ruehl wrote:
> hi @all,
> i new to your mail-list and need help with openbrick 
> and framebuffer/VGA
> 
> when i boot the openbrick the resolution is 720x576@50Hz 
> seems to me a PAL Video freqenz but i only use the nativ VGA Port
> 
> i found no Bios-Option to switch VGA only 
> 
> do you have a hint?
> 
> regards 
> chris ruehl wiesbaden Germany
> 
> -- 
> ----------------------------------------------------------------------------
>   ~.~  
>   / \  ./configure --sysconfdir=/etc
>   '''  ./make && ./make install         --  [email protected]
> 

ok - i found a solution,
 i remove jumper 4 and get a VGA compatible Signal.

but the framebuffer driver for the console cyber2000fb / vesafb 
leaves argly green dotts while refresh. (up to kernel 2.4.23)




-- 
----------------------------------------------------------------------------
  ~.~  Pinguine mit 64-Bit können auch nicht mehr stehen ;)
  / \  ./configure --sysconfdir=/etc
  '''  ./make && ./make install         --  [email protected]

signature.asc (application/pgp-signature, 240 B)

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: Weitere Infos: siehe http://www.gnupg.org

iD8DBQE/yvJXGKtS8nye7ZwRAtPlAJ0S3tHqQ4kH6Y5AcjHCktHiR91qdgCfV2Dw
udfuxVbqWsELxFzyZuVdHNY=
=v0Ym
-----END PGP SIGNATURE-----