RE: how to install dc9.62 on windows 7
"Dave McLaughlin" <[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
The only issue I have just now is getting a USB to Serial adaptor to work under Windows 7 64 bit. It is one of the original ZWorld/Rabbit recommended units with the FTDI chipset. It fails with timeouts trying to programme a RCM3000. My other stuff with the 4000 and 5000 processors are working fine under Windows 7 64 bit and a USB programming cable. You might be lucky and there is an application note on the Digi website about timeouts but so far this has not worked for me with this adaptor. Dave. From: [email protected] [mailto:[email protected]] On Behalf Of krishna Sent: 21 September 2012 18:31 To: [email protected] Subject: [rabbit-semi] how to install dc9.62 on windows 7 sir i am working with RCM3110 and rcm3100 kits my previous version of windows is winXP now i want to install dc9.62 in another system which is working on windows 7 OS can i install or it will not work properly any other software to install with dc9.62 for USB target response kindly help regards krishnadvs