RE: Re: Programming FPGA

"Fournier, Peter" <pfournier-P4RXiKWKZulWk0Htik3J/[email protected]>
Newsgroups gmane.comp.hardware.rabbit-semiconductor
Message-ID <[email protected]>
I can't send you a file here, I'll send one to your email.

For others who are reading this, the FPGA we are using is a Xilinx XC3S700-4FG400.  This one (there may be others as well) has a built in SPI programming capability.  We also included JTAG capability for design testing.  It took a couple of jumpers and an extra glue chip or two, but it works.

-Pete F
 

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of seecwriter
Sent: Wednesday, January 09, 2013 7:11 PM
To: [email protected]
Subject: [rabbit-semi] Re: Programming FPGA

Pete,

I'm looking into this again. We are using a XC95288XL CPLD. Once we get this working we'll move on to an FPGA.

Looking at AppNote 058 sample code, it bit thumps the JTAG pins. And it appears that a hardware SPI would not work because it changes modes by setting TMS and toggling TCK once. You can't do that with HW SPI.

What data type did you use?

Steve

--- In [email protected], "Fournier, Peter"  wrote:
>
> Last time we tried this, we discovered that the JTAG spec would have 
> cost us a lot of money.  The faster solution was to use SPI to the FPGA.
> I don't know which device you are using and whether it can do SPI, but 
> I think that is how the flash based devices work.  We are using the 
> xc3s700.
> 
> -Pete F
>  
> 
> -----Original Message-----
> From: [email protected] [mailto:[email protected]]
> On Behalf Of seecwriter
> Sent: Thursday, March 17, 2011 3:17 PM
> To: [email protected]
> Subject: [rabbit-semi] Programming FPGA
> 
> I have a requirment for a Rabbit to program a flash-based Xilinx FPGA 
> via a JTAG interface. The Rabbit would receive the data file via a 
> serial port and program the FPGA via its JTAG port. I've found alot of 
> info on using a JTAG port, but nothing that defines how to implement 
> the interface.
> 
> Does anyone know where I can get that level of detail? And words of 
> wisdom from anyone who's done this before are always welcome.
> 
> Steve
> 
> 
> 
> ------------------------------------
> 
> Yahoo! Groups Links
>




------------------------------------

Yahoo! Groups Links
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.