Re: bringing ARM CPUs into the RCM modules

"mhoneywill" <martin.honeywill-D/[email protected]>
Newsgroups gmane.comp.hardware.rabbit-semiconductor
Message-ID <[email protected]> 
I think the Freescale Kinetis K60 parts would make a good fit for an ARM3xxx board.

512K Flash
6 x Uart
Ethernet
Usb

Cheers

Martin

--- In [email protected], "Steven"  wrote:
>
> 
> I have contemplated the same thing but I always come back to just redesigning my whole main board.  If you were to go down the road of an "ARM3xxx" you might look at these ARM procs from ST, http://www.st.com/internet/mcu/subclass/1521.jsp
> 
>  
> --- In [email protected], Ian Lovatt  wrote:
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.