SPI TX pin is always high
"anand_gy2" <anand_gy2-/[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
Hello friends i am new to this group and also new to Rabbit microprocessors.. i am trying to monitor TX pin using SPI interface... I am using serial port B and SPI Dynamic C commands SPIwrite.. i have enabled my device as master clocked SPI mode.. Clock and CS line is functioning as per code..but i am not getting any output on TX pin,,it is always high.. 1 more thing ..i have not attached any SPI device to it.. i am just trying to monitor TX pins with different data.. I am very new to Dynamic C..so i may be making sily mistakes.. kindly help