Re: SPI TX pin is always high
"seecwriter" <seecwriter-/[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
Have you tried the example SPI program supplied with Dynamic C? --- In [email protected], "anand_gy2" <anand_gy2@...> wrote: > > Hello friends > i am new to this group and also new to Rabbit microprocessors.. > i am trying to monitor TX pin using SPI interface... > I am using serial port B and SPI Dynamic C commands SPIwrite.. > i have enabled my device as master clocked SPI mode.. > Clock and CS line is functioning as per code..but i am not getting any output on TX pin,,it is always high.. > 1 more thing ..i have not attached any SPI device to it.. > i am just trying to monitor TX pins with different data.. > I am very new to Dynamic C..so i may be making sily mistakes.. > kindly help >