Re: Specifying which device to program

Thanks for all the suggestions guys :-)



--- In [email protected], Scott Henion <shenion@...> wrote:
>
> On 10/15/2013 6:47 PM, jima wrote:
> >
> > Let us combine Scott's suggestion with the question.
> > Using Scott's suggestion of configuring a DigIn either high or low to
> > indicate which SBC you have, then combine both codes into one and in
> > YOUR CODE have the code configure the functions to be executed based
> > on this DigIn level.
> >
> > Now that I think of it I have done this so much I did not see the
> > solution until Scott mentioned it, WOW!
> > I need to step back out of the forest so I can see the trees again!
> >
> > Good answer Scott.
> 
> It also works to allow your code to adapt to different revisions of
> boards. If I change the hardware put something in to allow the code to
> "see" that  it is a new revision board.
> 
> -- 
> ------------------------------------------
>      Scott G. Henion, Consultant
> Web site:    http://SHDesigns.org
> ------------------------------------------
>