Re: RE: RCM6700 short circuit
Luiz Iniciante <cavaleiro_21-/E1597aS9LRfJ/[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
Thanks! De: "bill-N8kN8kpsG2dWk0Htik3J/[email protected]" <bill-N8kN8kpsG2dWk0Htik3J/[email protected]> Para: [email protected] Enviadas: Sexta-feira, 8 de Novembro de 2013 23:52 Assunto: [rabbit-semi] RE: RCM6700 short circuit Probably nothing is wrong. I/O that gets set to an output driving low (0V) will look shorted to ground because the output is 0V. Bill ---In [email protected], <cavaleiro_21@...> wrote: Hello Forum, I am using a RCM6700 module, programming a circut mounted on a interface using a prototyping board. I noticed several strange shorts that prevent the circuit from working properly. When I connect the 5V power supply to the development board pins P0-PE7 are shorted to ground as well as a few others such as PE7. However, when I remove the power supply, these pins are no longer shorted. Can anybody please explain what is wrong and how to fix it? Regards, L