RE: TCP sequence numbers.

<[email protected]>
Newsgroups gmane.comp.hardware.rabbit-semiconductor
Message-ID <[email protected]> 
Hi Steve,
 

 I had a similar problem last year.

 Try to turn off automatic crossover ("auto MDI-X" or "auto-uplink") of the Rabbit ethernet port (you can try with the switch ports also, if there is such option at all).
 

 Turn off auto negotiation too. Make sure to configure the right transmission parameters, such as speed, duplex mode, and flow control.
 

 Wish you success with this annoying eth problem,
 Alexander Hristov
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.