Re: Rusty with Dynamic C, need help loading code onto RCM4000

"Phil D [email protected] [rabbit-semi]" <[email protected]> Wed, 18 Feb 2015 08:51:00 +0000

Newsgroups	gmane.comp.hardware.rabbit-semiconductor
Message-ID	<CAL8BBoOQn6Mufw_nnZTDHzsGC8EYgCekQR-J89-ARtBrRLCpyg@mail.gmail.com>

SMODE jumper! needs to be held low for normal operation

Phil

On 18 February 2015 at 03:11, veitchsp-/[email protected] [rabbit-semi] <
[email protected]> wrote:

>
>
> I've written code in Dynamic C.  I can compile and run it.  But when I
> disconnect the USB programming cable, the software stops.  Does anyone know
> how to get your code loaded onto the RCM and have it power up and run code
> independently?
>
>  
>