RE: Re: Rusty with Dynamic C, need help loading code onto RCM4000
"'Fournier, Peter' pfournier-P4RXiKWKZulWk0Htik3J/[email protected] [rabbit-semi]" <[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
I think most of us have put a switch on the wire so we can leave the cable connected and just use the switch to go from programming to debug. The connectors wears out fast or the wires break if you do a lot of taking it off and putting it on. -Pete F From: [email protected] [mailto:[email protected]] Sent: Saturday, February 21, 2015 6:18 PM To: [email protected] Subject: [rabbit-semi] Re: Rusty with Dynamic C, need help loading code onto RCM4000 Thanks for the help. Turns out I just needed to remove the programming cable from the 10 pin header once I burned the *.bin to flash. Works like a champ.
image001.jpg
(image/jpeg, 332 B) - not displayed
image002.jpg
(image/jpeg, 359 B) - not displayed