Re: Rabbit 6000: conflict between Ethernet and aux I/O

"emanuele.zini-/[email protected] [rabbit-semi]" <[email protected]>
Newsgroups gmane.comp.hardware.rabbit-semiconductor
Message-ID <[email protected]> 
Thank you Steve,
 

 we finally found the problem.
 

 We copied BOARDTYPES.LIB from RCM6700 but in that board PG0 and PG1 are used for Ethernet : Link Led and Activity Led. In our design these ports are used as strobe for aux I/O.
 

 I hope this post will be useful for designer using Rabbit 6000 and looking at RCM6700 for hw and sw.
 

 Thank you very much for your help.
 

 Emanuele
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.