RE: Programming over USB

"'Tom Collins' tom-lnEA/wrDJtNWk0Htik3J/[email protected] [rabbit-semi]" <[email protected]> Thu, 17 Dec 2015 14:08:38 -0800

Newsgroups	gmane.comp.hardware.rabbit-semiconductor
Message-ID	<[email protected]>

You might want to try using clrfu from Dynamic C 10.72.  The GUI from that release can program Rabbit2000/3000 boards, so there’s a good chance the command-line version can as well.  And it’s likely that version has better USB support.

 

-Tom

 

From: [email protected] [mailto:[email protected]] 
Sent: Tuesday, December 15, 2015 11:58 AM
To: [email protected]
Subject: [rabbit-semi] Programming over USB

 

  

Has anyone successfully programmed an R3k module using the clrfu and a USB adapter? The manual says using USB is an option, but I can't get it work. I usually get error, "Error reading bytes". I can communicate with the Rabbit using a USB adapter, just not reprogram it.  Programming works fine using the serial port with the same set of cables. 

 

Commandline: clrfu .\myfile.bin -s 4:115200 -cl .\coldload.bin -pb .\pilot.bin -v -vp- -usb+

 

I'm using the adapter that Z-World used to recommend. I think it's Tripp-lite.

 

Steve