Re: Motherboard design for RCM6700 series

You will have more than enough experience i had a very similar task within
3 months of starting work.

Look at the development kit schematics as a starting point, note that
serial B is used for the serial flash so avoid using that as an external
UART.

Good luck
On 18 Mar 2016 3:00 p.m., "Steve Trigero seecwriter-/[email protected]
[rabbit-semi]" <[email protected]> wrote:

>
>
> You shouldn't have much difficulty. It's fairly straight forward. IMO,
> professional help (consultant) would be overkill.
>
>
> ------------------------------
> *From:* "[email protected] [rabbit-semi]" <
> [email protected]>
> *To:* [email protected]
> *Sent:* Friday, March 18, 2016 8:18 AM
> *Subject:* [rabbit-semi] Motherboard design for RCM6700 series
>
>
> I have less than 2 years experience in hardware designing and I was assign
> to use the schematics for the RCM6700 on digi.com to design necessary
> documents needed to manufacture 10- 15 mother/interface board.  This board
> must have 3 UART, backup, and a Ethernet port.  How difficult is it to
> accomplish this task with my level of experience?  Or should I seek
> professional help, if so where?  Thanks
>
> Racq
>
>
>
> 
>