Re: DC and rabbitlib

Which board are you using?  For Rabbit 2000 and 3000, you need to use Dynamic C 9 (http://www.digi.com/support/productdetail?pid=5053).  If you already have 9.62 installed, be sure to get the latest patches from that page or GitHub (see below).

For Rabbit 4000, 5000 and 6000 you can use Dynamic C 10 (http://www.digi.com/support/productdetail?pid=4978).  The latest release is 10.72A, and I'd highly recommend using it.  The early Dynamic C 10 releases were buggy, and it didn't start hitting it's stride until around 10.60 or so.

Both DC 9 and 10 have been released as Open Source on GitHub (https://github.com/digidotcom/DCRabbit_10 and DCRabbit_9).  You can go there to get the latest updates for both releases.

For rabbitlib, it sounds like this SourceForge project: https://sourceforge.net/projects/rabbitlib/

-Tom


On Sep 1, 2016, at 5:42 PM, Massimo Manca [email protected] [rabbit-semi] wrote:
> I am not using DC since 2006 and now I need to do a short modification
> on a Rabbit RCM board.
> 
> 1. Last release I have is DC 10, is there something new compatible with it?
> 
> 2. I didn't remember where I downloaded rabbitlib a zip containing some
> libs don't published by Z-World/Digi, can anyone point me where can I
> download it?