Re: DC and rabbitlib

Il 02/09/2016 23:46, Tom Collins tom-lnEA/wrDJtNWk0Htik3J/[email protected] [rabbit-semi] ha scritto:
>  
>
> Which board are you using?  For Rabbit 2000 and 3000, you need to use
> Dynamic C 9 (http://www.digi.com/support/productdetail?pid=5053).  If
> you already have 9.62 installed, be sure to get the latest patches
> from that page or GitHub (see below).
>
Thanks, you are right, the board is a 3000 family so the right one
should be DC9. I have to re install it.
>
> For Rabbit 4000, 5000 and 6000 you can use Dynamic C 10
> (http://www.digi.com/support/productdetail?pid=4978).  The latest
> release is 10.72A, and I'd highly recommend using it.  The early
> Dynamic C 10 releases were buggy, and it didn't start hitting it's
> stride until around 10.60 or so.
>
> Both DC 9 and 10 have been released as Open Source on GitHub
> (https://github.com/digidotcom/DCRabbit_10 and DCRabbit_9).  You can
> go there to get the latest updates for both releases.
>
> For rabbitlib, it sounds like this SourceForge
> project: https://sourceforge.net/projects/rabbitlib/
Yes, right, thanks Tom.
>
> -Tom
>
>
> On Sep 1, 2016, at 5:42 PM, Massimo Manca [email protected]
> <mailto:[email protected]> [rabbit-semi] wrote:
>> I am not using DC since 2006 and now I need to do a short modification
>> on a Rabbit RCM board.
>>
>> 1. Last release I have is DC 10, is there something new compatible
>> with it?
>>
>> 2. I didn't remember where I downloaded rabbitlib a zip containing some
>> libs don't published by Z-World/Digi, can anyone point me where can I
>> download it?
>
> 




---
Questa e-mail è stata controllata per individuare virus con Avast antivirus.
https://www.avast.com/antivirus

begin:vcard
fn:Massimo Manca, Micron Engineering
n:Manca;Massimo
org:Micron Engineering
adr:;;via della Ferriera, 48;Pordenone;PN;33170;Italia
email;internet:[email protected]
tel;work:+39 0434 1856131
tel;cell:+39 349 4504979
url:http://www.micronengineering.it
version:2.1
end:vcard