Re: streaming to multiple HD1K units

Ron
I have the same problem with the HD1000 needing to be "Primed"
I have found that if you launch the aquarium program before running
streamplayer 0.1d, streams start fine. I have sent out a mail list question
on this in the past and received nothing back. It seems that Streamplayer is
missing some initialization item.
On the Linkstation question, I believe the Linkstation is on the hairy edge
of being fast enough feed one TS stream much less two. I can run two SD
streams off of it (on the main drive, not the USB drive) but two TS streams
get weird
..Barry

----- Original Message ----- 
From: "Ron" <[email protected]>
To: "'Roku Tech Mail List and Discussion Group'"
<[email protected]>
Sent: Wednesday, June 30, 2004 2:06 PM
Subject: RE: [Roku-tech] streaming to multiple HD1K units


I haven't tried multiple units yet, but I have seen the 'first play'
problems.  It is almost like the HD1000 has to be primed before you can use
it.

> -----Original Message-----
> From: [email protected] [mailto:roku-tech-
> [email protected]] On Behalf Of brendan
> Sent: Tuesday, June 29, 2004 10:21 AM
> To: [email protected]
> Subject: [Roku-tech] streaming to multiple HD1K units
>
>
> Hello all -
>
> I have been using the HD1K without problems thus far. I have a LinkStation
> connected directly to the unit and plays HD transport streams fine (I did
> notice the when it first plays it has difficulties). I am wondering if
> anyone
> has tried streaming multiple videos to different units at the same time?
> i.e...
> one LinkStation to two or three units playing the same video stream - or
> different videos.
>
> Thanks in advance to all that reply,
> bS
>
> _______________________________________________
> Roku-tech mailing list
> [email protected]
> http://lists.rokulabs.com/mailman/listinfo/roku-tech


_______________________________________________
Roku-tech mailing list
[email protected]
http://lists.rokulabs.com/mailman/listinfo/roku-tech