Re: OpenBSD 5.6 on a 4801?

Change default console to tty0.

-
Regards,
Nick
Sent from my Motorola Nexus 6

On Apr 10, 2015 3:40 AM, "Peter Bako" <[email protected]> wrote:
>
> Has anybody successfully installed OpenBSD 5.6 on a net4801?  I have two of
> these units (both with the latest 133 firmware), each failing in the exact
> same way, at the exact same place, while doing a PXE install.  I can see my
> TFTP server being queried for pxeboot, bsd.rd and boot.conf, so I know the
> PXE setup is correct.  On my serial terminal I can see the box starting the
> BSD boot, loads the kernel then displays "entry point at 0x200120" and
> stops.  Thinking it just might be slow I've left sitting for as long as 10
> minutes, but it just hangs there.  Since both units are doing this I am
> wondering if there was a change in OpenBSD which causes the install to fail
> on these older units...
>
> Thanks,
> Peter
>
> _______________________________________________
> Soekris-tech mailing list
> [email protected]
> http://lists.soekris.com/mailman/listinfo/soekris-tech