net6501 red error light and blinking eth0-eth3?

Hi all,

I have OpenBSD on a net6501 which was working fine, however after the last
reboot it shows a constant red "error" light and sporadically rapidly
blinks all the eth0-eth3 lights. After a minute or so the eth0-eth3 lights
blink again but the error light stays on.
No SSH access and nothing on the RS232 console.
+12V from the internal 230VAC PSU seems fine with a multimeter, also +3V is
OK on a small coin-battery on the board.

Any ideas?

thanks,
Anders

_______________________________________________
Soekris-tech mailing list
[email protected]
http://lists.soekris.com/mailman/listinfo/soekris-tech