Re: Timer interrupt frequency (50Hz vs 60 Hz)
Alex Evans via Coco <coco-uNHYcr1XS/wmlAP/[email protected]>
| Newsgroups | gmane.comp.hardware.tandy.coco |
|---|---|
| Message-ID | <CAD7WSBSNH32=yKpe74O9m4RSXD4nsqGJ7CpNQXOGsZw-=SiHPg@mail.gmail.com> |
You could use something like the sync instruction with interrupts masked. On Thu, Mar 20, 2025, 21:17 RETRO Innovations via Coco <coco-uNHYcr1XS/wmlAP/[email protected]> wrote: > On 3/20/2025 7:51 PM, Alex Evans via Coco wrote: > > The trouble I see is that both hsync and hsync are IRQ though you can > check > > the pia to see which one fired. > Apologies, I thought one was IRQ and the other FIRQ. But yes, you could > check PIA. > > There is also the issue that servicing an > > IRQ is not really fast because all of the registers are preserved. > > Well, my thought is that this code would only run once for at most 1/25 > of a second (worst case situation is that fsync irq is enabled > immediately following an FSYNC IRQ, so it would run one frame without > counting, and then the next it would count. But, the below code can be > optimized if needed. > > My main is whether it would give different values on NTSC versus PAL. I > assume so, since there would be 262 or 263 hsyncs in NTSC, but 312/313 > in PAL. > > > > > On Thu, Mar 20, 2025, 20:33 RETRO Innovations via Coco < > coco-uNHYcr1XS/wmlAP/[email protected]> > > wrote: > > > >> On 3/20/2025 7:07 PM, Alex Evans via Coco wrote: > >>> Yes, you can interrupt (IRQ) on hsync on any coco. > >> So if you write: > >> > >> prep: > >> > >> //put 0 in NUM > >> > >> // put 0 in START > >> > >> //enable fsync > >> > >> // wait for START to equal 2 > >> > >> // use NUM value to calc PAL or NTSC > >> > >> > >> fsync_IRQ > >> > >> // increment START > >> > >> // if START = 1 > >> > >> // zero out NUM, enable hsync, and return > >> > >> // else disable fsync and hsync and return > >> > >> hsync_IRQ: > >> > >> // increment NUM > >> > >> // return > >> > >> Would the above give you different numbers in NUM you could use to > >> determine PAL/NTSC? > >> > >> Jim > >> > >> -- > >> RETRO Innovations, Contemporary Gear for Classic Systems > >> www.go4retro.com > >> store.go4retro.com > >> > >> > >> -- > >> Coco mailing list > >> Coco-uNHYcr1XS/wmlAP/[email protected] > >> https://pairlist5.pair.net/mailman/listinfo/coco > >> > > -- > RETRO Innovations, Contemporary Gear for Classic Systems > www.go4retro.com > store.go4retro.com > > > -- > Coco mailing list > Coco-uNHYcr1XS/wmlAP/[email protected] > https://pairlist5.pair.net/mailman/listinfo/coco > -- Coco mailing list Coco-uNHYcr1XS/wmlAP/[email protected] https://pairlist5.pair.net/mailman/listinfo/coco