Re: PCFSRV V2.5

On 3/19/2026 7:03 PM, John Guin via Coco wrote:
> Just kibbutzing with a vague, old memory:
> 
> Should/could you run CLOADM after the BASIC stub loads but before you 
> run that stub?

I did, but I may try again.  But the only thing I have loaded so far
is the BASIC program.  In any event, unless I am missing something,
I don't see where the "Load" command tries to load anything.  The
value it tries to EXEC is the address located at address 27 and 28
minus a number that appears to the length of the mystery program.

> 
> You could also add that command to a (new) line 371.

Also worth a try.

> 
> It may also need to be CLOADM”   (again, vague memory of the cassette 
> load syntax which allowed for an open quote to load whatever was next on 
> the tape, regardless of name).

Just CLOAD will do that.

> 
> And finally, I may be completely wrong about this.
> 
> Good luck!
> 

Not going to spend a lot of time on it but I was curious.  I think
I only paid something like $20 for it.

bill

-- 
Coco mailing list
[email protected]
http://listserv.adelphi.edu/cgi-bin/mailman/listinfo/coco