| Newsgroups |
gmane.comp.hardware.texas-instruments.msp430.discuss |
| Message-ID |
<[email protected]> |
Thanks, I am very familiar with the DF13 series and have used it for
many years, but it doesn't suit my current application which uses ECG
type flexible cabling that is too large to be crimped in these
connectors, and which cannot be substituted by the typical pre-made (and
very expensive) cables I have used before. The cables will be between
1.5 and 2.0mtr long.
Thanks
Al
On 20/08/2014 1:53 PM, [email protected] [msp430] wrote:
>
>
> Hirose DF13 series might suffice. You do have to crimp ends onto
> wires, then insert the pins into connectors.There are online suppliers
> of finished wire with ends attached, ready for insertion.
>
> These are positive lock, very robust.
>
> They are the connectors used all over the Pixhawk controller,
> ArduPilot controller, etc.
>
> Pixhawk Autopilot - PX4 Autopilot Platform
> <http://pixhawk.org/modules/pixhawk>
>
>
>
> Pixhawk Autopilot - PX4 Autopilot Platform
> <http://pixhawk.org/modules/pixhawk>
> Pixhawk Autopilot PIXHAWK is a high-performance autopilot-on-module
> suitable for fixed wing, multi rotors, helicopters, cars, boats and
> any other robotic platform that can move.
>
> View on pixhawk.org <http://pixhawk.org/modules/pixhawk>
>
> Preview by Yahoo
>
>
>
>
>
>