RE:Solution] IAR Unable to download release version via jtag
| Newsgroups | gmane.comp.hardware.texas-instruments.msp430.discuss |
|---|---|
| Message-ID | <[email protected]> |
Original message:Speaking of IAR, I run their MSP430 assembler. But it is an older version that does not support the 20 bit addresses. Any suggestions were I can get an update on this? Okay, we get lazy. After using a tool forever, we forget that there is documentation that comes along with it. Good news is, I did update my assembler and linker to version 6.10 and 6.0 from something in the 4.0 range. The answer to the question is the -v option. Using -v0 uses the MSP430 native instructions Using -v1 uses the MSP430X instruction set. Blakely -- Blakely LaCroix Minneapolis, Minnesota, USA