| Newsgroups |
gmane.comp.hardware.texas-instruments.msp430.discuss |
| Message-ID |
<[email protected]> |
I was trying to RTFM (in between other duties) in order to help Mike out. Being unfamiliar with the processor and only searching the PDF (i.e. not printing it out) with "temperature sensor" did not lead to Table 60. There it is "Temp. Sensor". Therefore, the information might have been a little harder to find than it should have been.
BTW, I looked at the Family Guide, too.
Thanks for the specific reference and a mild RTFM.
Emmett Redd Ph.D. mailto:[email protected]
Professor (417)836-5221
Department of Physics, Astronomy, and Materials Science
Missouri State University Fax (417)836-6226
901 SOUTH NATIONAL Lab (417)836-3770
SPRINGFIELD, MO 65897 USA Dept (417)836-5131
In statesmanship get the formalities right, never mind about the moralities. -- Mark Twain.
________________________________________
From: [email protected] [[email protected]]
Sent: Wednesday, September 24, 2014 4:05 PM
To: [email protected]
Subject: Re: [msp430] MSP430F5438A on-board temperature sensor calibration data
On 09/24/2014 02:14 PM, [email protected] [msp430] wrote:
>
>
> Hi Folks, Would someone please tell me where to find the calibration
> values for the temperature sensor for this chip when using 2.5 volt
> reference voltage?
See table 60 in the device data sheet. (aka RTFM)
> I suppose they are designated as something like CALADC12_25V_30C...
It appears that the intent was that you would parse the TLV structure
looking for the ADC12 tag rather than use absolute addresses although it
is a bit more work.
--
David W. Schultz
http://home.earthlink.net/~david.schultz
Returned for Regrooving
------------------------------------
Posted by: "David W. Schultz" <[email protected]>
------------------------------------
To unsubscribe from the msp430 group, send an email to:
[email protected]
------------------------------------
Yahoo Groups Links
------------------------------------
Posted by: "Redd, Emmett R" <[email protected]>
------------------------------------
To unsubscribe from the msp430 group, send an email to:
[email protected]