Re: MSP430F5528 - Clock and UART

Hi All,

First off, The first rule of software development is that the best code is
the one you didn't have to write ^^.

I agree with Al here, why aren't you using the build in UART tool in the
microprocessor. It is build to be used in this way, and the only reason
ever not to is if you have to use a certain chip and you have run out of
UART ports to use.

@Martin: Now you are just poking the bear aren't you.

Cheers,
Jake

On Tue, Feb 17, 2015 at 2:07 PM, Onestone [email protected] [msp430] <
[email protected]> wrote:

>
>
> Why oh why are you bit banging this when the MSP430 has an extremely
> simple UART in hardware. Are interrupts that fightening?
>
> Al
>
>
> On 18/02/2015 2:21 AM, [email protected] [msp430] wrote:
>
>
>
>
>  Hello, I'm trying to communicate with my RF module through UART
> interface. However, I get many errors even with low load. I suspect that
> I have an issue with the way that I configure the clock or the UART.
>
>
>  Basically, for the UART functionality I use
> http://glitovsky.com/blog/?p=300
>
> (I configured the connection as 8N1 at 115200).
>
>
>  The clock configuration below is used with MCLK = 25 MHz ( when I use it
> with MCLK=16 MHz I cannot communicate with the UART module at all ) .
>
>
>   P5SEL |= 0x0C;
>
>   /* Select REF0 for FLL reference. */
>
>  UCSCTL3 &= ~SELREF_7;
>
>  UCSCTL3 |= SELREF_2;
>
>
>   /* Set ACLK to use REF0CLK.
>
>    * Set SMCLK to use the DCO.
>
>   */
>
>   UCSCTL4 &= ~SELA_7 & ~SELS_7 & ~SELM_7;
>
>   UCSCTL4 |= SELA_2 | SELS_4 | SELM_4;
>     /* Initialize FLL. */
>    Init_FLL_Settle(mclk/1000L, mclk/32768);
>
>     XT2_Start(XT2DRIVE_0);
>
>     UCSCTL4 &= ~SELA_7;
>      UCSCTL4 |= SELA_2;
>    UCSCTL8 |= SMCLKREQEN | MCLKREQEN | ACLKREQEN;
>    /* Enable interrupt for TBCCR0. */
>     TBCCTL0 = CCIE;
>
>   /* Number of ticks per millisecond. */
>     clock.aclk = 32768;
>     clock.ticks_per_interrupt = clock.aclk / 1000;
>     TBCCR0 = clock.ticks_per_interrupt;
>
>      /* Use ACLK, set timer to up-count mode, and start timer at zero. */
>     TBCTL = TBSSEL_1 | MC_2 | TBCLR;
>
>     /* Enable interrupts. */
>     __bis_SR_register(GIE);
>
>
>  Thanks,
> Mike
>
>
>
>
>
>
>
>
>
>
>  
>



-- 
Thomas J. Grajewski