Re: Re: Need help with msp430 software
| Newsgroups | gmane.comp.hardware.texas-instruments.msp430.discuss |
|---|---|
| Message-ID | <[email protected]> |
The behavior is inconsistent. On one trial vim took input from the device, but the command line did not. That seemed odd, but I didn't pursue the matter. On a 2nd trial some time later using a different terminal window, both vim and the command line took input from both buttons. Neither case crashed Linux. However, that means nothing as I've had it work properly several times and then crash before. mspdebug 0.23 is having problems with the ezfet firmware which got updated at least once by CCS. TI's USB firmware for the F5529LP got munged. Prior to running CCS I had loaded the blinky demo using Energia with the board clocked at both 16 & 25 MHz. That no longer works. It reports "no unused FET found". I'll have to figure out how to load a plain hex image using CCS or the serial bootloader. Linux crashing is a separate matter, which I do not intend to pursue. I don't use Linux for anything important. I use it to run software that can't be compiled on Solaris or is only available as a binary blob for Linux. ------------------------------------ Posted by: Reginald Beardsley <[email protected]> ------------------------------------ To unsubscribe from the msp430 group, send an email to: [email protected]