Re: Random number generator in assembler

"'Steve Mayfield' [email protected] [msp430]" <[email protected]> Mon, 8 Jun 2015 00:11:55 -0700

Newsgroups	gmane.comp.hardware.texas-instruments.msp430.discuss
Message-ID	<B73A84422DAD4A42BF4ECF5702BF799D@System7>

why not use the ID to determine the RF signal delay time? That way, the receiver will also know when a device doesn’t send its signal too...

From: mailto:[email protected] 
Sent: Sunday, June 07, 2015 11:25 PM
To: [email protected] 
Subject: [msp430] Random number generator in assembler

Does anyone know of a simple way of randomising some data in assembler. I want to send a RF signal between noon and 1300 hours. There are quite a few transmitters and I do not want them to all send off at once. Each has a unique ID numbered from 1-65000.

TIA

Peter

Peter Grey