RE: MSP430 active / low-power modes ratio

You could turn a led on at the beginning of the active cycle and off at the
end. Check with a CRO and see the ratio.

Peter

-----Original Message-----
From: [email protected] [mailto:[email protected]] 
Sent: Tuesday, 30 June 2015 12:07 AM
To: [email protected]
Subject: RE: [msp430] MSP430 active / low-power modes ratio

Fahmi,

"Count your cycles" is all the advice we can give until you supply more
details.

Emmett Redd Ph.D.   mailto:[email protected]
Professor                                 (417)836-5221
Department of Physics, Astronomy, and Materials Science
Missouri State University             Fax (417)836-6226
901 SOUTH NATIONAL                   Lab (417)836-3770
SPRINGFIELD, MO  65897   USA    Dept (417)836-5131

In statesmanship get the formalities right, never mind about the moralities.
-- Mark Twain.
________________________________________
From: [email protected] [[email protected]]
Sent: Monday, June 29, 2015 8:49 AM
To: [email protected]
Subject: [msp430] MSP430 active / low-power modes ratio

Hi,

I need to determine the ratio between the time spent in active mode and the
time spent in low-power mode for an application running on an MSP430 MCU.


Regards,

Fahmi





------------------------------------

------------------------------------

To unsubscribe from the msp430 group, send an email to:
[email protected]


------------------------------------

Yahoo Groups Links






------------------------------------
Posted by: "Peter Grey" <[email protected]>
------------------------------------

To unsubscribe from the msp430 group, send an email to:
[email protected]