Re: using in-board ez430 FET emulator
John Willauer <[email protected]>
| Newsgroups | gmane.comp.hardware.texas-instruments.msp430.gcc.user |
|---|---|
| Message-ID | <[email protected]> |
How do I eliminate the "Segmentation fault" I get when I try it using:
Ubuntu 12.04
mspdebug 0.18-1
gdb-msp430 7.2~mspgcc-7.2.2
gcc-msp439 4.5.3~mspgcc-201
--
John
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
On 06/20/2013 09:53 AM, Jose Luis Honorato L. wrote:
> Hi Ravim,
>
> I can't see the output messages you intended to include, but here's a short
> how-to. I just hope you don't have a specific problem with your setup.
>
> You can use the ez430-FET emulator to program the msp-exp430f5529 without
> any external hardware. Just plug your mini USB cable to the lower left USB
> connector (the one in the ez430-FET emulator) and run:
>
> sudo mspdebug rf2500 "prog bin.elf"
>
> That should program the device after a few console messages.
>
> You can use mspdebug with gdb too, for that you should:
>
> 1. Run mspdebug (sudo mspdebug rf2500)
> 2. In mspdebug, type gdb
> 3. In another window, run msp430-gdb
> 4. In gdb, type target remote localhost:2000
> 5. Done
>
> This is assuming you have all these tools installed, if not there are
> plenty of guides out there on how to install them.
>
> Kind regards,
> Jose
> _______________________________________________
> Mspgcc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/mspgcc-users
------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:
Build for Windows Store.
http://p.sf.net/sfu/windows-dev2dev
_______________________________________________
Mspgcc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/mspgcc-users