Re: Upgrading from gdbproxy to mspdebug - a couple of questions

On Mon, Aug 26, 2013 at 02:21:41PM +1200, Andrew McLaren wrote:
> >mspdebug -j uif
> ...
> Searching for firmware for TI3410...
>     - checking c:/MinGW/msys/1.0/local/lib//mspdebug/ti_3410.fw.ihex
>     - checking ti_3410.fw.ihex
> ti3410: unable to locate firmware
> ti3410: firmware download failed
>  
> This lead me onto the issues with the FET firmware (I hadn't touched this up
> to this point), and the documentation in the sourceforge pages on upgrading
> to V3. As per the suggestions there, I have tried to dump the current
> firmware before I update it, which gives me the following;

Hi Andrew,

The firmware download goes into RAM on the TI3410 -- there are no
permanent changes made. If you have a device already (COMx), you can use
the -d option:

    mspdebug -j uif -d COMx

What's the actual debugger hardware you're using? Are you connecting to
the chip via JTAG or Spy-Bi-Wire?

Cheers,
Daniel

-- 
Daniel Beer <[email protected]>    www.dlbeer.co.nz
IRC: inittab (Freenode)    PGP key: 2048D/160A553B

------------------------------------------------------------------------------
Introducing Performance Central, a new site from SourceForge and 
AppDynamics. Performance Central is your source for news, insights, 
analysis and resources for efficient Application Performance Management. 
Visit us today!
http://pubads.g.doubleclick.net/gampad/clk?id=48897511&iu=/4140/ostg.clktrk