How to connect to a running target using MSPDebug

Hello,

I am currently using MSP430FR5994. I program and debug it using MSP430.dll
v3.3.1.4. I am unable to connect a running device to mspdebug without
causing a reset to the program.

I want to connect  a running target to mspdebug without stopping it or
resetting the device. Currently. I connect to my device using 'tilib'
driver. I get the following status after which the device is reset:
Using new (SLAC460L+) API
MSP430_Initialize: /dev/ttyACM0
Firmware version is 31001600
MSP430_VCC: 3000 mV
MSP430_OpenDevice
MSP430_GetFoundDevice
Device: MSP430FR5994 (id = 0x01e9)
3 breakpoints available
MSP430_EEM_Init
Chip ID data:
  ver_id:         82a1
  ver_sub_id:     0000
  revision:       10
  fab:            55
  self:           5555
  config:         10
  fuses:          55
warning: unknown chip

Thank you.





--
Sent from: http://msp430-gcc-users.1086195.n5.nabble.com/

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot