Getting started

I installed horde and imp over the last two days.  What a chore!  I
finally went with the horde-supplied rpms (RH9) and it's been working
great.  By far the trickiest part was the authentication.  So, I'd tell
you what authentication I am using, but I don't know.  authinfo shows a
bunch of compiled auth modules.  However, authtest gives me nothing but
failures (even with the -m authwhatever).  But remember, horde and imp
actually work!  I can send and receive mail.  Go figure.  Which brings
me here....

I downloaded jonah today (tar, v 0.0.2).  It sounds like a fantastic
project.  Installed it in horde/jonah and followed the INSTALL that came
with it.  The part concerning conf.php does not address the Admin
configuration section at all.  I'm not sure what settings I should have
in there.  What's more, when I browse to 
https://pelorus.org/horde/jonah/backend.php?mode=update
I get a popup that asks for a username and password.  I have tried every
combination of passwords that I am using.  Root, mysql, horde, users,
admin.... none of them work. So I have not been able to do a download. 
Oh, the jonah/test.php works, but I do get one error message:

* Looking for the HTMLDocument package: No
* I did not find the file ../package.HTMLDocument.php. Make sure that
Jonah is installed inside a recent installation of Horde.

  I don't know what else to add here, but hopefully someone can get me
pointed in the right direction.

Skip


-- 
Jonah mailing list
Frequently Asked Questions: http://horde.org/faq/
To unsubscribe, mail: [email protected]