Re: Getting started

Zitat von Skip Morrow <[email protected]>:

> I installed horde and imp over the last two days.  What a chore!  I
> finally went with the horde-supplied rpms (RH9) and it's been working
> great.  By far the trickiest part was the authentication.  So, I'd tell
> you what authentication I am using, but I don't know.  authinfo shows a
> bunch of compiled auth modules.  However, authtest gives me nothing but
> failures (even with the -m authwhatever).  But remember, horde and imp
> actually work!  I can send and receive mail.  Go figure.  Which brings
> me here....

What auth modules are you talking about? Obviously not Horde's unless you
found a way to compile PHP.

> I downloaded jonah today (tar, v 0.0.2).  It sounds like a fantastic
> project.  Installed it in horde/jonah and followed the INSTALL that came
> with it.  The part concerning conf.php does not address the Admin
> configuration section at all.  I'm not sure what settings I should have
> in there.  What's more, when I browse to
> https://pelorus.org/horde/jonah/backend.php?mode=update
> I get a popup that asks for a username and password.  I have tried every
> combination of passwords that I am using.  Root, mysql, horde, users,
> admin.... none of them work. So I have not been able to do a download.
> Oh, the jonah/test.php works, but I do get one error message:

http://horde.org/source/versions.php

Jan.

--
http://www.horde.org - The Horde Project
http://www.ammma.de - discover your knowledge
http://www.tip4all.de - Deine private Tippgemeinschaft

-- 
Jonah mailing list
Frequently Asked Questions: http://horde.org/faq/
To unsubscribe, mail: [email protected]