GUI stuck at min or max

So I'm not sure where I went wrong, first time using sizers maybe.
Wrote the original code on WinXP went over to Win2000 and when I try to 
open the designer or run the code in any mode, the application is either 
always maximized or minimized there's no in between.

Is this a simple 1st timer mistake or should I post the code to get some 
help.

WinXP works as expected a small box in the middle 400x600 maybe.

Thanks,
Alex


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/