Re: PPM can't access ppm4.log and perltoc.html

Eric Robertson wrote:
> I have Komodo 5.03 and Perl 5.8 on my Mac and I was installing the module
> CGI::Session using ppm from the Tools/Run Command. The module seemed to
> install OK but I did get a couple of errors - "Can't log to .../ppm4.log"
> and a similar one for perltoc.html. I looked at the latter and couldn't find
> any entry for this new module, which presumably should have been there.
> 
> I looked at the permissions for perltoc.html and these showed as Read &
> Write for system but only Read for admin and everyone so I changed that so
> that all showed Read & Write and reran the installation again but I still
> got the same error. I had done a similar thing for ppm4.log but for that
> file there was no entry for the owner so I couldn't change this.
> 
> I assume that this is a permissions problem but how do I change it so that
> ppm can access these two files?

Do you get the same error when running the same ppm command from the 
shell? If so, your best bet would be to ask on the ActivePerl mailing list:
http://aspn.activestate.com/ASPN/Mail/Browse/Threaded/ActivePerl

Trent


-- 
Trent Mick
trentm at activestate.com
_______________________________________________
Komodo-discuss mailing list
[email protected]
To unsubscribe: http://listserv.ActiveState.com/mailman/mysubs
Other options: http://listserv.ActiveState.com/mailman/listinfo/Komodo-discuss