Re: Using Subversion in Komodo

Anton, thanks for the reply. I should have thought about using update  
in my situation. However when I tried it on the folder that contained  
the missing file I got the message showing the latest revision number  
but no indication of having transferred the file, and when I looked at  
the working directory it still wasn't there. I've checked again and  
it's definitely in the repository. I assume that if I wanted to  
restore an earlier version (there's not one here) I would have to use  
copy.

I did also try to check that I could amend a file and update the  
repository all right but there I got a message that I didn't have  
permission to create the entry required although I do have admin  
rights. I got round this by using sudo in Terminal - incidentally my  
repository in currently a local one on my hard drive. Could it be that  
permissions are causing my other problem, and how do I start up Komodo  
with admin rights?

Regards
EricR



On 8 May 2009, at 13:09, Anton Visser wrote:

> Eric,  easier way to restore a file, would be to right click on the
> folder containing the file, in the project view, on the left hand
> side. Then select Source Control -> Update.  This will update the
> contents of your folder, restoring the missing file and updating that
> folder, with any code committed by someone else.
>
> cheers,
> Anton
>
> On Fri, May 8, 2009 at 6:56 AM, Eric Robertson <[email protected] 
> > wrote:
>> I'm using subversion for the first time and I'm having a problem with
>> restoring a file from the repository.
>>
>> I'm using Komodo 5.1.3 on my Mac and have set up a repository using  
>> svn,
>> created a working directory and loaded all the files I require into  
>> my
>> Komodo project. I wanted to see if I could restore a file that had  
>> been
>> deleted so I removed a file from the project and sent it to trash.  
>> I then
>> copied the file from the repository into my working directory,  
>> running the
>> command from Run in Komodo, and then used Add/Existing File to get  
>> the file
>> back into my project.
>>
>> My problem is that there's no tick against this file in Komodo and  
>> its
>> properties are not showing that it is under source code control.  
>> I've tried
>> Refresh Status to no avail.
>>
>> I must be doing something wrong. What is the correct way of  
>> restoring a file
>> and getting it back into a Komodo project?
>>
>>
>> _______________________________________________
>> Komodo-discuss mailing list
>> [email protected]
>> To unsubscribe: http://listserv.ActiveState.com/mailman/mysubs
>> Other options: http://listserv.ActiveState.com/mailman/listinfo/Komodo-discuss
>>
>


_______________________________________________
Komodo-discuss mailing list
[email protected]
To unsubscribe: http://listserv.ActiveState.com/mailman/mysubs
Other options: http://listserv.ActiveState.com/mailman/listinfo/Komodo-discuss