RE: Hacking the Actiontec PCI card

Nice one Andy, good to see your spending your time constructivily :o) Can
you get your friend with the mapping software to get us a 3D graph of the
strengths of this thing?


--Ben

-----Original Message-----
From: Rob Kyle [mailto:MBCX0RK2-RHlZi5nFZCOi2/woJv4GR1pr/1R2p/[email protected]]
Sent: 04 October 2002 12:50
To: [email protected]
Subject: Re: [consumebristol] Hacking the Actiontec PCI card


Good work.

You should probably use as little RG58 as poss.  I used it before 
and it gave pretty crappy results.

Rob

> I've finally pulled my finger out and done it!  Took about an hour, what
> with waiting for the soldering iron to warm up, and doing the write-up.
> Dead easy to do.  I've written full instructions at
> http://consume.andylaurence.co.uk/actiontec.shtml
> 
> Andy


Bristol Consume Website: http://consume.andylaurence.co.uk/
Bristol Consume Discussion: http://consume.cyberprog.net/
Administrivia: To Subscribe send an e-mail to
[email protected] with the subject subscribe. To unsubscribe
send with the subject unsubscribe.
To post to the list just e-mail [email protected] or hit
reply in your mail client.

All reasonable precautions have been taken to ensure no viruses are present
in this e-mail. Midwest Technologies Limited cannot accept responsibility
for loss or damage arising from the use of this e-mail or attachments and
recommend that you subject these to your virus checking procedures prior to
use.
This e-mail (including attachments) is confidential.  If you are not the
intended recipient you must not print, copy or distribute it. If you have
received this e-mail in error, please notify us immediately by replying to
this e-mail and delete this e-mail from your system. 
Where the contents of this e-mail are the opinion of the writer only, they
are not endorsed by Midwest Technologies Limited unless expressly stated
otherwise.

Bristol Consume Website: http://consume.andylaurence.co.uk/
Bristol Consume Discussion: http://consume.cyberprog.net/
Administrivia: To Subscribe send an e-mail to [email protected] with the subject subscribe. To unsubscribe send with the subject unsubscribe.
To post to the list just e-mail [email protected] or hit reply in your mail client.