RE: Build failed

Ok, that did the trick!

Thanks a lot for the tip. :-)


> -----Original Message-----
> From: Cameron Fieber [mailto:[email protected]]
> Sent: 26 August 2004 4:25
> To: [email protected]
> Subject: RE: Build failed
> 
> 
> Try
> C:\Documents and Settings\<your username>
> 
> Which is probably also the directory that contains your .magic
> directory.
> 
> Setting merlin.deployment.timeout=0 should make the build succeed, as
> the error that was occurring was from the timeout expiring, and a
> timeout of 0 means never timeout.
> 
> -Cameron
> 
> On Wed, 2004-08-25 at 12:08, David Leangen wrote:
> > Cameron,
> > 
> > Thanks, that makes sense.
> > 
> > > What environment are you running in (OS, JVM version, etc) and how
> > > much load is on your machine while your build is running?
> > 
> > Not much load. It's about the only process running, other than 
> the typical
> > background stuff.
> > 
> > Running WinXP with 1.4.1_02-b06.
> > 
> > 
> > > If you create a merlin.properties file in your home 
> directory, with the
> > > value: merlin.deployment.timeout=0
> > > It should use that when running the test case and basically wait
> > > forever for the component to commission.
> > 
> > Forgive my silly question, but what would be considered my 
> "home" directly
> > under Windows? I tried setting merlin.deployment.timeout=0 in a 
> few places
> > to make it fail, but the property was not set in each location 
> where I saved
> > the merlin.properties file.
> > 
> > 
> > Thanks a lot for your help!
> > 
> > Dave
> > 
> > 
> > 
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: [email protected]
> > For additional commands, e-mail: [email protected]
> > 
> > 
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]