Re: How to get TLS working
Sir Dotcom <[email protected]>
| Newsgroups | gmane.comp.jakarta.james.user |
|---|---|
| Message-ID | <[email protected]> |
My whole conf dir is "stock" except for the key passphrase's. The only change I made was the one I did below (which comments it should be that way anyway.) And yes, I tried all combinations of being auth'd and not or TLS and not. Unless I'm reading it wrong (quite likely) it was treating my mail as "foreign" because it wasn't from localhost, or at least that's what that line seems to say. Working great now, just lots of spam rejection. Regards, Steve On 12/21/21 8:27 PM, [email protected] wrote: > Are you sure the SMTP user is authenticated? > > Can you share your smtpserver.xml and mailetcontainer.xml files? > > Be careful of not sharing possibly sensible information. > > Benoit > > On 21/12/2021 23:38, Sir Dotcom wrote: >> I finally got it straightened out ... I was being routed away by the >> RemoteAddr mailet here: >> >> <!-- If you are using SMTP authentication then you can (and generally --> >> <!-- should) disable this matcher/mailet pair. --> >> <!-- <mailet match="RemoteAddrNotInNetwork=127.0.0.1" >> class="ToProcessor"> >> <processor>relay-denied</processor> >> <notice>550 - Requested action not taken: relaying >> denied</notice> >> </mailet> --> >> >> Since I'm using AUTH it now sends the mail! >> >> Regards, >> >> Steve >> >> >> --------------------------------------------------------------------- >> To unsubscribe, e-mail: [email protected] >> For additional commands, e-mail: [email protected] >> >> > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected]