Re: conversion tool 9 to 10

> On Jan 12, 2026, at 6:36 PM, Robert Turner <[email protected]> wrote:
> 
> I didn't use the tool myself when migrating -- just did it the
> old-fashioned way with search and replace. So I cannot answer the second
> question. I would however assume it runs "in place" on your source code

Ok. I will try source = destination
> (and of course since you are using source code control, that's fine....
> right ... you are using source code control...right .. if not, best to
> start)
> 
Yes. It’s an open source project at gitlab
> I would suggest the whole code base myself. But I would refer to the tool
> documentation for how best to run it.
> 
>> On Mon, Jan 12, 2026 at 8:33 PM Rob Sargent <[email protected]> wrote:
>> 
>> 
>> 
>>>> On Jan 12, 2026, at 3:55 PM, Rob Sargent <[email protected]> wrote:
>>> 
>>> 
>>> 
>>>> On Jan 12, 2026, at 1:27 PM, Robert Turner <[email protected]>
>> wrote:
>>>> 
>>>> You will need to migrate any code using javax.servlet -- you may also
>> have
>>>> strings (for instance attribute names) using "javax.servlet" -- these
>> also
>>>> need changing. Sometimes web.xml has such references as well.
>>>> 
>>>> After running the conversion tool, search everything for "javax.servlet"
>>>> and ensure they are updated or do not need to be (like text in a log
>> file
>>>> that is not important).
>>>> 
>> 
>> Shall I then assume “Nothing” and “No” for my other questions?
>> 
>> rjs
>> 
>> 
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: [email protected]
>> For additional commands, e-mail: [email protected]
>> 
>>