[mevenide-user] Advice on test design

All,

I *know* this is mostly off-topic for this list (and I apologise in
advance), but I figure this is still a good place to start.

I am running Netbeans 5.5 with mevenide trying to decide how I attack
the following problem:

Let's assume that I'm writing some code that uses a properties file to
define some parameter or other. In the absence of the properties file,
the code should use a sensible default value. So, I have the following
tests to run

1) No properties file - default behaviour
2) Properties file with nonsense value - default behaviour with warning
3) Properties file with sensible value - use supplied value

How do I run tests 1 *and* 2/3 in the same project given that the test
properties file is either supplied or not (as far as I can tell) in
src/test/resources.

Later,

Andy

-------------
Yada, yada, yada...

Roslin Institute is a company limited by guarantee, registered in
Scotland (registered number SC157100) and a Scottish Charity (registered
number SC023592). Our registered office is at Roslin, Midlothian, EH25
9PS. VAT registration number 847380013.

The information contained in this e-mail (including any attachments) is
confidential and is intended for the use of the addressee only.   The
opinions expressed within this e-mail (including any attachments) are
the opinions of the sender and do not necessarily constitute those of
Roslin Institute (Edinburgh) ("the Institute") unless specifically
stated by a sender who is duly authorised to do so on behalf of the
Institute.
 

---------------------------------------------------------------------
To unsubscribe from this list please visit:

    http://xircles.codehaus.org/manage_email