Re: Change working directory for build

Spam detection software, running on the system "caladin.urbancode.com", has
identified this incoming email as possible spam.  The original message
has been attached to this so you can view it (if it isn't spam) or block
similar future email.  If you have any questions, see
the administrator of that system for details.

Content preview:  Ok, I was just ruling out other possiblities and looks
  like you have covered your bases. But here's an example of what I was
  talking about: At the top of your build.xml, after the project entry
  you can set order of precedence by using the following properties [...] 

Content analysis details:   (5.0 points, 5.0 required)

 pts rule name              description
---- ---------------------- --------------------------------------------------
 0.9 FROM_ENDS_IN_NUMS      From: ends in numbers
 1.1 MAILTO_TO_SPAM_ADDR    URI: Includes a link to a likely spammer email
 2.2 RCVD_IN_BL_SPAMCOP_NET RBL: Received via a relay in bl.spamcop.net
               [Blocked - see <http://www.spamcop.net/bl.shtml?65.54.168.200>]
 0.1 RCVD_IN_SORBS          RBL: SORBS: sender is listed in SORBS
                            [65.54.168.27 listed in dnsbl.sorbs.net]
 0.8 MSGID_FROM_MTA_HEADER  Message-Id was added by a relay

_______________________________________________
Anthill mailing list
Anthill-IWHQxnLZ/[email protected]
http://lists.urbancode.com/mailman/listinfo/anthill