Re: constructor pointcut

Hi Shiyiying.

Unfortunately, I have not implemented support for advising of 
constructors yet. It is on my task list and I will definitely implement 
it. For now you have to use the static factory pattern to be able to 
advise object creation.

Sincerely, Jonas.


shiyiying wrote:
> Hi Jonas:
> Today  I decide to write a configuration aspect for my all configurable class.
> This configuration aspect would check all jointpoint after these class's constructor body is executed .Then it would read corresponding configurable properties from a property file, config this new created instance using reflection.
> I think I need a constructor post advice,but I cannot found any imformation about constructor  jointpoint.
> Best Regards!
> Shiyiying
> N¬±ù޵隊X¬²š'²ŠÞu¼“†)äç¤Yé\¢g­¢ž’š½éá¶Ú?þØbžHzG(›ûjÊ^rÜ®LÝz÷¥¢—«™¨¥Šx%ŠËZ²—œ·«“7^½éh¥êåŠËl²‹«qç讧zØm¶›?þX¬¶Ë(º·~Šàzw­þX¬¶ÏåŠËbú?jÊ^rÜ®LÝz÷¥¢—«


-- 
Jonas
http://freeroller.net/page/jboner





-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf