Re: Controlling Failed Builds...

HI Glenn,

If you set the buildafterfailed attribute to false in your project tag, I 
think that will do it.

Regards,
Steve

From: Glenn Boysko
Sent: Friday, February 10, 2012 3:23 PM
To: [email protected]
Subject: [Cruisecontrol-user] Controlling Failed Builds...


Hello:



I have basic question about the CruiseControl build loop and controlling it 
for failed builds. I know that when a build is successful, it will not build 
again until there are modifications. However, when a build fails, 
CruiseControl keeps rebuilding on interval specified by the schedule 
element. I guess this is due to the fact that modifications that caused the 
failure are not “consumed” and thus remain as modifications until the build 
is successful.



Is there a way for CruiseControl to “consume” the original modifications 
that caused the first build failure and not try to build again until a new 
set of modifications arrive?



Thanks,

Glenn



------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/

_______________________________________________
Cruisecontrol-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/cruisecontrol-user 


------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing 
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
Cruisecontrol-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/cruisecontrol-user