Re: Enhydra 5.1/Kelp 5.1: JBuilder9 always recompiling whole project

On Mon, 2003-12-22 at 17:50, James Carnegie wrote:
> - go to: Project Properties | Run (tab) 
> - then click "edit" for the runtime configuration that you are using.
> - then select <none> as build target.
> 
> That should do it. Good luck.

Thanks James, but unfortunately this is not the fix I am searching for.
I have been using JBuilder with Enhydra since version 3 and the "Make"
never recompiled the project when there were no changes. Now it does
(Kelp 5.1).

Your advice basically stops compiling the project even if there were
changes made to the source files. I actually want the "Run" to compile
the changed files but not EVERYTHING, especially not XMLC stuff because
that one takes ages and is waste of my time as HTML files weren't
touched.

Petr


> 
> James.
> 
> On Mon, 2003-12-22 at 15:52, Petr Stehlik wrote: 
> > Hi,
> > 
> > JBuilder9 keeps recompiling the whole project even if there is no change
> > in source files - whenever I click on 'Run' it starts with XMLC and then
> > the whole java source files set.
> > 
> > Any idea how to fix this?
> > 
> > Petr
> > 
> > 
> > _______________________________________________
> > Enhydra mailing list
> > [email protected]
> > http://www.enhydra.org/mailman/listinfo.cgi/enhydra