Activities/Steps question

Forgive me if I get the terminology wrong:

I created an XPDL document (using JAWE) that has five steps - in a
linear fashion.  Step two is always done after step one, step three
always after step two, etc.

When I _create_ the process, I already know which group should be
assigned to each step.

However, when I call the createProcess() method, and interrogate the
WfProcess, it appears there is only one activity (and that one only
exists after the start() method has been called).  

Am I to assume there is no way to assign all of these activities to the
proper owner when the process is created and I must assign them as each
activity is completed?

Thanks,
Greg
******* Confidentiality Notice *******
This email, its electronic document attachments, and the contents of its website linkages may contain confidential health information.  This information is intended solely for use by the individual or entity to whom it is addressed.  If you have received this information in error, please notify the sender immediately and arrange for the prompt destruction of the material and any accompanying attachments.

--
You receive this message as a subscriber of the [email protected] mailing list.
To unsubscribe: mailto:[email protected]
For general help: mailto:[email protected]?subject=help
ObjectWeb mailing lists service home page: http://www.objectweb.org/wws