Re: {Spam?} Re: {Spam?} RE: Starting Process

Hi Frans,

i think you are getting confused between a process *definition* and 
process *instances*. The process defintion is what is contained in the 
xpdl. Once an xpdl file is loaded into Shark, Shark can create *instances* 
of this process (as defined by the xpdl). Please look at this for a very 
nice explanation of what these terms mean in the workflow world:

http://www.wfmc.org/standards/docs/TC-1011_term_glossary_v3.pdf

The info about the pkgId and the processId is in the xpdl. Please see my 
last email about where to look for them.

Regards,
Geeta (*please*, no"r" in my name!!! ;))




Frans Thamura <[email protected]> 
07/25/2005 11:31 AM
Please respond to
[email protected]


To
[email protected]
cc

Subject
{Spam?} Re: {Spam?} RE: [shark] Starting Process






Hi Greeta,

I success put your code inside my WorkflowManager aka JSPUtilites.

I just want a tips how to use it

what is packageId, processId, Map variableAndValues.?

I think I want to instantiace "testWRD#1#ComplexWRDs", how to get the 
packageId, processId from this process?

i look at SharkAdmin and cannot get those, the process propieties only 
show Name, Categoruy, Version, Active processes, and state.

have a simple case for this?

Frans


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


--
You receive this message as a subscriber of the [email protected] 
mailing list.
To unsubscribe: mailto:[email protected]
For general help: mailto:[email protected]?subject=help
ObjectWeb mailing lists service home page: http://www.objectweb.org/wws


CONFIDENTIALITY NOTICE:This email is intended solely for the person or 
entity to which it is addressed and may contain confidential and/or 
protected health information.  Any duplication, dissemination, action 
taken in reliance upon, or other use of this information by persons or 
entities other than the intended recipient is prohibited and may violate 
applicable laws.  If this email has been received in error, please notify 
the sender and delete the information from your system.  The views 
expressed in this email are those of the sender and may not necessarily 
represent the views of IntelliCare.

--
You receive this message as a subscriber of the [email protected] mailing list.
To unsubscribe: mailto:[email protected]
For general help: mailto:[email protected]?subject=help
ObjectWeb mailing lists service home page: http://www.objectweb.org/wws