RE: Process context default values

Thank you. After double-checking it, it was a problem of JaWE in fact.
When assigning nulls to the default values, JaWE put a special value
instead. The solution is to assign "", then the default value is really
empty.

Best regards,

David.


> Hi David,
>  
> Only thing I can think of is that Formal Parameters Don't have Initial
> values, Everything else does, However, you can set the Default value
> to 'null' if you wish.
>  
> Neville van Deventer
>  
> PS: Get to testing Shark 1.1-2 as fast as possible, many nice
> improvements...
> 
> 
> ______________________________________________________________________
> From: David Simón [mailto:[email protected]] 
> Sent: 24 August 2005 11:54 AM
> To: [email protected]
> Subject: RE: [shark] Process context default values
> 
> 
> Hi,
> 
> I have a simple question, if somebody could help me. When I
> instantiate a process and get its context, the variables have default
> values, is there any way to not have these default values? A
> configuration parameter o something like that? I would like to have
> the variables not initialized with any value.
> 
> BTW, I'm using Shark 1.0 (looking forward to testing 1.1)
> 
> Thank you.
> 
> Best regards,
> 
> David.  
> plain text document adjunto (message-footer.txt)
> 
> --
> You receive this message as a subscriber of the [email protected] mailing list.
> To unsubscribe: mailto:[email protected]
> For general help: mailto:[email protected]?subject=help
> ObjectWeb mailing lists service home page: http://www.objectweb.org/wws

--
You receive this message as a subscriber of the [email protected] mailing list.
To unsubscribe: mailto:[email protected]
For general help: mailto:[email protected]?subject=help
ObjectWeb mailing lists service home page: http://www.objectweb.org/wws